OUR PROJECTS
NO JOB IS TOO LARGE OR TOO SMALL
LOADER BUCKET
JOB DETAILS
- Hired by GVEA to fabricate and weld a spill guard for a 980M loader to be used at their Healy coal plant.
- It took approximately 24-hours to fabricate, weld, and paint.
- Cost for material/labor was approximately $7,000.
- Lincoln LN-25 and Hyper-Therm power max 85 plasma cutter were the primary pieces of equipment used for this project.
DUMP TRUCK TRAILER HITCH
JOB DETAILS
- Fabricate and welded a hitch plate and safety chain D-rings to an end dump for a local excavation company.
- Project took approximately 10 hours.
- Cost for material and labor was approximately $1400.
- Lincoln LN-25 and Hyper-Therm power max 85 plasma cutter were the primary pieces of equipment used for this project.
REBAR INSTALLATION FOR CONCRETE PAD
JOB DETAILS
- Prepped area with #4 rebar for a concrete pad.
- Cost for material and labor was approximately $2,000.
CUSTOM FUEL TANK
JOB DETAILS
- 50 gal transfer tank welded inside and out with 1/8 thick steel.
- Two baffles, drain plug, lifting eyes, and pressure tested.
- Approximately 8 hours to complete the job.
- $300 in materials. Total cost $800-$1000.
OFFICE & AFTER HOURS
907-490-8989
WORKING HOURS
Mon-Sat: 7:30AM – 6:00PM
AFTER HOURS EMERGENCY